|
Ham Page |
|
Favorite Sites |
|
NOTICE: ALL INFORMATION ON THIS SITE AND PAGES HERE IN ARE FOR INFORMATION ONLY! THE TRANSMIT MODIFICATION BELOW IS FOR THE ICOM-746 AND SHOULD BE DONE AT YOUR OWN RISK. |
|
REMOVE BOTTOM COVER FROM RADIO AND LOCATE THE MAIN BOARD. IN THE PICTURE BELOW IT SHOWS TWO (2) DIODES TO REMOVE. THESE ARE D1713, AND D1714 AND ARE IN A ROW OF FOURTEEN (14) LOCATED ON THE LEFT SIDE WITH RADIO FRONT TOWARDS YOU. NOT ALL LOCATIONS ARE USED. TAKE EXTREME CARE IN REMOVING THESE DIODES. |
|
ICOM - 746 Modification |
|
ICOM-746 MOD LOCATION |
|
USE A LOW WATT SOLDERING PEN AND SOLDER WICK TO REMOVE THESE TWO DIODES. IT WILL TAKE SEVERAL ATTEMPTS TO REMOVE ENOUGH SOLDER TO FREE THE DIODES WITHOUT CAUSING DAMAGE FROM OVER HEAT. AFTER REMOVAL REPLACE BOTTOM COVER. NO CPU RESET! |
|
Remove these |
|
Home Page |